1992-1997 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved 4 FORD F-SERIES 7.3L POWER STROKE Fuel Pressure Gauge Installation SECTION 4 1. Remove the engine cover using an 11mm socket. 2. Locate the fuel filter housing and remove the driver side Schrader valve using a 7/16 wrench. Note: Have a drain pan ready as a few drops of fuel will leak out. 3. Thread the fuel pressure sensor into the fuel filter housing and tighten using a 22mm wrench. Note: Do not overtighten the sensor. 4. Now that the fuel pressure sensor is installed to the housing, connect the sensor wire harness into the female port on the sensor until you hear a click. 5. Route the sensor wire along the firewall to the driver side of the engine bay and secure the wiring with zip ties to ensure no contact with any direct heat source and moving parts. 6. Re-install the engine cover. 2. 3. 5. Fuel PSI Sensor Port
RkJQdWJsaXNoZXIy MTIxODAy