1992-1997 INSTALLATION GUIDE 3 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved FORD F-SERIES 7.3L POWER STROKE Transmission Temp Gauge Installation SECTION 3 Note: If you are installing a MaxTow Transmission Temperature Gauge, the connectors are already attached to the Transmission Temperature Sensor Harness and can simply be plugged into the Transmission Temperature Sensor before routing the wire to the firewall. Optional: Safely jack up the truck for easier access to the driver’s side of the transmission. 1. Wrap the Transmission Temperature Sensor threads with Teflon tape. 2. Using an 11mm wrench, remove the transmission test port located on the driver’s side above the second transmission pan bolt from the front of the truck. Note: Have a drain pan available to catch any leaking fluid. 3. Thread the sensor into the test port and tighten using a 14mm wrench. Note: Do not overtighten. 4. Attach the female silver connector and the longer rubber cover to one end of the green wire from the Gauge Wiring Harness and connect it to the white wire from the sensor. 5. Attach the male silver connector and shorter rubber cover to the end of the end of a wire from the Gauge Wiring Kit and connect to the black wire from the sensor. 6. Route the Transmission Temperature Sensor wires to an opening on the firewall on the driver’s side of the engine bay and use zip ties to secure. Make sure there is no contact with any direct heat source or moving parts of the truck. Optional: Lower the vehicle if it was raised. 7. Connect the Transmission Temerature Sensor ground wire to a reliable grounding source in the engine bay. 8. Top off the trans fluid according to manufacturer specifications if needed. 3. 2. 5.
RkJQdWJsaXNoZXIy MTIxODAy