1992-1997 INSTALLATION GUIDE 5 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved FORD F-SERIES 7.3L POWER STROKE HPOP Gauge Installation SECTION 5 1. Locate the Injection Control Pressure (ICP) Sensor located next to the driver side valve cover. 2. Unclip the factory harness connector and plug in the HPOP Gauge Wiring Harness pigtail to both ends. 3. Route the HPOP Pressure Sensor Signal Wire to an opening on the firewall on the driver’s side of the engine bay and use zip ties to secure. Make sure there is no contact with any direct heat source or moving parts of the truck. Connect the Green signal wire from the gauge to the Green signal wire from the harness. 4. Connect the Black signal wire from the gauge to the Black signal wire from the harness. 5. If you are not installing the High Pressure Oil Pressure HPOP Gauge Wiring Harness, connect the green signal wire from the gauge to the signal wire of the ICP Sensor Harness. Note: See chart below. 6. Connect the Black ground wire from the gauge to the ground signal wire of the ICP sensor harness. Note: See chart below. 1. 2. 3.-4. OPtional HPOP Gauge Wiring pigtail Vehichle Sensor Wire Color Ground Wire Color Ford 1994-1996 Powerstroke 7.3L Dark Blue/Lt Green Gray/Red Ford 1997 Powerstroke 7.3L Lt Blue/Red Gray/Red
RkJQdWJsaXNoZXIy MTIxODAy