2014-2019 INSTALLATION GUIDE 7 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved CHEVY / GMC DURAMAX 1. 2. 9. 1. Carefully remove the factory trim from the truck by removing the bolt covers with a flat blade screwdriver and remove the two 10mm pillar retaining bolts. 2. Wrap Teflon Tape around the brass fitting on the back of the boost gauge, then attach the brass fitting using a 13mm wrench. Note: Do not overtighten. 3. Mount the gauges in the triple pillar gauge pod in any configuration you prefer. There is no specific order required. 4. Feed the wires from each gauge into the pillar pod. 5. If you are using the optional 3 Gauge Wiring Kit, attach all of the wires together. 6. Connect all of the yellow wires using a crimp connector. 7. Connect all of the red wires using a crimp connector. 8. Connect all of the orange wires using a crimp connector. This enables the dimming function that will lower the brightness of your gauges 30% for easier viewing when driving at night. 9. Connect all of the black wires using a crimp connector. 10. Secure all wires with zip ties. 11. Using a 10mm socket, remove the 3 nuts that are holding the module under the dash in the driver footwell area in order to gain access to the firewall. Unplug all of the plugs on the front and back of it. 12. Cut the nipple on the main harness pass-through grommet which is located under the master cylinder in the engine bay. 13. Route the sensor wires and boost line through the firewall, into the cab of the truck, and up to the gauges, keeping clear of any moving parts. Installing The Pillar Pod SECTION 5
RkJQdWJsaXNoZXIy MTIxODAy