2014-2019 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved CHEVY / GMC DURAMAX 8 14. Insert the boost line into the Ferrule Fitting Adapter, thread onto the back of the gauge and tighten with a 3/8” Wrench. (Refer to diagram below) Note: Do not overtighten the Ferrule Fitting. 15. Plug the EGT Sensor Harness into the back of the EGT Gauge. (If used) 16. Splice the green signal wire from the Transmission Temperature Gauge to the white signal wire from the sensor. (If used) 17. Plug the Fuel Pressure Sensor Harness into the back of the Fuel Pressure Gauge. (If used) 18. Insert the supplied plastic clip into the upper oval hole of the truck cab where the spring clip was secured. 19. Mount the pillar pod to the truck cab A-pillar, securing it with the supplied pillar mounting screw and a Phillips head screwdriver. 20. Route the power and ground wires to the fuse box under the hood on the drivers side, making sure to pass through the grommet in the firewall. PROPER ORIENTATION 19. 15. 18.
RkJQdWJsaXNoZXIy MTIxODAy