2000-2006 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved 8 GMC SIERRA CHEVY SILVERADO DURAMAX Installing the Pillar Pod SECTION 6 1. Carefully remove the factory trim from the truck by pulling and releasing the spring clips. Note: This gauge pod mounts directly on top of your truck’s A-pillar using the supplied pushin clips and is not a complete replacement. 2. Place the triple pillar pod overtop of the removed factory trim. Mark and drill (4) 7/32” holes and secure with the flush mount fasteners. 3. Mark and drill holes using a Step Bit for the wiring to pass through the factory trim. 4. Now you can mount the gauges in the triple pillar gauge pod in any configuration you prefer. There is no specific order required. 5. Wrap Teflon Tape around the brass fitting on the back of the Boost gauge, then attach the brass fitting using a 13mm Wrench. Note: Do not overtighten. 6. Feed the wires from each gauge into the pillar pod. 7. Insert each gauge into the pod. 8. If you are using the optional 3 Gauge Wiring Kit, attach all of the wires together. 9. Connect all of the yellow wires using a crimp connector. 10. Connect all of the red wires using a crimp connector. 11. Connect all of the orange wires using a crimp connector. This enables the dimming function that will lower the brightness of your gauges 30% for easier viewing when driving at night. 12. Connect all of the black wires using a crimp connector. 13. Secure all wires with Zip Ties. 14. Route the sensor harnesses and boost line through the firewall and into the cab of the truck, keeping clear of any moving parts. Note: You may need to drill a hole in the firewall if there isn’t one already. It is important to use a grommet on the hole to ensure the wires are not sliced or cut on the firewall. 15. Insert the boost line into the Ferrule Fitting Adapter, thread onto the back of the gauge and tighten with a 3/8” Wrench. (Refer to diagram) Note: Do not overtighten the Ferrule Fitting. 16. Plug the EGT Sensor Harness into the back of the EGT Gauge. (If used) 17. Splice the green signal wire from the Transmission Temperature Gauge to the green signal wire from the sensor. (If used) 18. Plug the Fuel Pressure Sensor Harness into the back of the Fuel Pressure Gauge. (If used) 19. Splice the green and black wires from the Fuel Rail Pressure Gauge to the green and black wires from the Fuel Rail Pressure Pigtail Harness. (If used) 20. Mount the pillar pod and factory trim assembly to the truck cab A-pillar, securing it with the factory spring clips. 1. 8. 15. PROPER ORIENTATION
RkJQdWJsaXNoZXIy MTIxODAy