1998.5-2002 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved 4 DODGE RAM 24V 5.9L CUMMINS Transmission Temp Gauge Installation SECTION 3 1. Safely jack up the truck, if not raised already. Locate the middle test port plug on the passenger side of the transmission case. Using an 11mm Wrench, remove the test port plug. Note: Have a drain pan available for any fluid that will leak from the fitting. 2. Wrap Teflon Tape clockwise around the male threads of the sensor and test port extender adapter. Thread the sensor into the test port extender adapter and tighten using a 17mm Wrench and 14mm Wrench. 3. Thread the test port extender with the sensor attached into the transmission test port and tighten using a 17mm Wrench. 4. Connect the signal wire of the gauge to the white wire of the temperature sensor and connect the black wire of the sensor to any reliable grounding location. 5. Route the wires up to the firewall on the driver side of the engine bay and use Zip Ties to secure the sensor wires to ensure there is no contact with any direct heat source or moving parts. 1. 2. 3. TEST PORT EXTENDER
RkJQdWJsaXNoZXIy MTIxODAy